28 in. User Manual

STEP 1

1) Remove the Clevis Pin (8), Nut (9), Spring Washers (11), Flat Washers (12) & Bolt (10) on

Coupling (14).

2) Loosen the Screw (1) from

Hanger Ball (3), remove the

Hanger Ball (3) and Lock Pin (2).

3) Route the wires and safety

wire from the motor through the

Downrod (7).

4) Install the Downrod (7) to

Coupling (14) and secure with

Bolt (10), Flat Washer (12),

Spring Washer (11), Nut (9) &

Clevis pin (8).

5) Tighten the 2 Set Screws (13)

on the Coupling (14) to serve as

a clamping force on the Downrod

(7) to prevent fan shaking during

operation.

6) Route the Coupling cover (6), Canopy Ring (5), Canopy (4) and Hanger Ball (3) through the

Downrod (7) in turn, and then install the Lock pin (2) through the hole on the Downrod (7). Slip

the hanger ball (3) upward to lock Pin (2), and fix it by Screw (1), then slip down the Coupling

Cover (6) in correct position.

INSTALLATION INSTRUCTION