Assembly Instruction

Hardwire Installation
1 2
64 5
Remove the kock-out by hammering Disengage adapter plate by loosening screw. Insert romex connector into the housing open hole
on the adapter plate. Secure it with the nut.
Pull 3 wires out of the fixture to allow connection to
the branch circuit.
Inserting wires into the open hole in the push-in
wire connector
Connect the Green ground input supply wire to the
fixture Green ground wire.
Connect the White input supply wire to the fixture
White wire.
Connect the Black input supply wire to the fixture
Black wire.
**Do not mix wires or change polarity.
1
2
Fix the fixture to the unit using 2 fixing screws Connect the multiple fixtures by snapping the End to End Connetcor or Jumper Connector.
3
Finally wire the power cord to 120v mains supply.
3
Feed wires back into fixture, reattach adapter
plate tighten screw, and attach the fixture to the
base of the cabinet, with screws
4
By flipping the switch (a) select between one of
the 3 modes (Lo, Off, Hi ).
Switch (b) is used to change the color
temperature of light delivered 2700K, 3000K &
4000K CCT respectively.
Page 4 of (4)
a
b