Assembly Instruction

A
B
C
D
Page 4 of (4)
1
2
1. Turn off power for appropriate electrical circuit at electrical service panel.
2. Remove Junction Box cover screws and remove cover.
3. Locate exposed power wiring exiting from wall.
4. Install the 3/8" miniature die-cast electrical connector (included with the junction box) through the hole in the back of the
junction box.
5. Feed supply wires through this connector and into the junction box.
6. Tighten connector’s screws to hold the wired in place.
7. Make sure the mounting surface is mechanically sound and free of obstruction(s). Affix junction box to underside of cabinet
with captive screws provided.
8. Make electrical connections matching wire colors (black to black and white to white) and secure with wire nuts provided.
9. Ensure that no bare wires are exposed after electrical connections have been made and wire nuts are in place.
10. Arrange the wires inside the box.
11. Replace and secure wiring junction box cover with supplied screws, being sure that all wires and connections are
positioned inside the box and no wires are
pinched between the lid and the box.
12. Restore circuit power at electrical service panel. Turn on master switch on junction box and turn on switches on each
individual fixture. Master switch can be
used to control all fixtures simultaneously or fixtures can be operated individually.
Black Wire
White Wire
3/8" Miniature
Die-Cast Electrical Connector
Jumper Cable to Connect to Fixture
(Sold Separately)
Jumper Cable to Connect to Fixture
(Sold Separately)