Assembly Instruction

CounterMax MX-LD-AC
53830-53832-53835-53836
RECESS/SURFACE
INSTALLATION
LIGHT
INSTRUCTIONS
IMPORTANT : Please read these instructions before commencing installation and retain for future reference.
Important Safety Information
Please read these instructions carefully before attempting to install
WARNING: To avoid electrical shock, use only with 120V AC plug-in power
this product. It is advisable to keep these instructions in a safe place supply or with 120V AC hardwire power supply.
for further reference.
Factory warranty will be void if used with a non-recommended power supply,
WARNING: These products may represent a possible shock or fire
transformer, or driver.
hazard if improperly installed or attached in any way. Products should
be installed in accordance with these instructions, current electrical
Risk of shock or fire hazard:
codes and/or the current National Electric Code (NEC).
The maximum number of pucks that can be interconnected to a power cord,
or to a port on the hardwire box is 20. Do not exceed in any single run.
WARNING: To avoid electrical shock, disconnect or disable power at
Each puck consumes 4.3 watts.
the source prior to installation or maintenance.
Safety Instructions
1.
The CounterMax MX-LD-AC Puck is listed c/ETL/us and intended for indoor use in
4. Do not secure unit or its power cord with staples, nails, or any other sharp
dry locations only. Do not use in the vicinity of standing water or liquids. objects that may damage the cords.
Do not submerge in water or liquids.
5. Please read and understand these instructions before beginning installation.
2. Do not use if there is any damage to the unit or to the power cord’s
insulation. Inspect periodically.
3. Do not route cords or units through walls, doors, windows or any similar
part of a building structure.
Prior To Installation
CounterMax MX-LD-AC LED 3-pack Kits include three LED Pucks, a 6' plug-in 120V power cord and mounting hardware. To extend a three puck kit, purchase single bulk pucks
to reach the quantity needed, up to twenty. Single puck kits contain a puck with only a lead wire and so this puck has to be the last puck in a
series.
Determine the quantities and locations of CounterMax MX-LD-AC Pucks
needed, and whether pucks will be surface mounted or
recessed. CounterMax MX-LD-AC Pucks use the “Daisy Chain” System for
power input.
Page 1 of 2