Installation Sheet

PRODUCT NAME: Rail Vanity Bath
ITEM NUMBER: 52100 52102 52103 52104
MADE IN CHINA
Below is a List of Recommended Dimmers:
Due to inrush current wattage should not exceed
150 Watts of product for a 600 Watt dimmer.
12W 16W 20W 24W
This fixture is designed to dim with a standard Triac
forward phase dimmer. Dimming levels will vary
by dimmer.
Please consult a qualified electrician for hanging fixture and wiring.
CAUTION:Before starting the installation, disconnect the power by
turning off the circuit breaker or by removing the fuse at the fuse box.
Carefully unpack and identify all parts before assembly
·
Lutron MACL-153M
·
Lutron DVL-153P
·
Lutron SCL-153P
·
Leviton IPL06-10Z
·
Leviton 6674-POW
1. Always disconnect power at the main electrical panel before installation.
2. Pull wall box wires through center hole of mounting plate. Secure mounting
plate to wall using screws so that the fixture mounting points are aligned
vertically. (See Fig. 1)
3. Follow wiring instructions Fig. 2.
4. After connecting all wires, push all wires and wirenuts back through center .
hole of mounting plate and into the cavity of the electrical box,
while positioning the fixture to align with the mounting points / tabs.
5. Secure decorative back plate with screws at top to the mounting plate. (See Fig. 3)
Fig. 2
Mounting
Plate
Wirenut
Outlet Box
Supply Wire
Decorative
Back Plate
Fig. 3
Screw
Mounting
Plate
Decorative
Back Plate
Fig. 1
Mounting
Plate
Box Screw
Outlet Box
Supply Wires
Outlet Box
120VAC LED