Assembly Instruction

Table Of Contents

PRODUCT NAME: Motion 3 Light Bath Vanity

ITEM NUMBER: 27553WTPC

MADE IN CHINA

Page 1 of (2)

Bulb (included): 3*40W G9 Bulbs

Please consult a qualified electrician for hanging fixture and wiring.

Caution: Xenon bulbs get very hot and may burn

you. Always make sure bulbs are off for a

minimum of 10 minutes before handling. Fixture

may be dimmed using an electronic low voltage

dimmer.

PAGE 1
PRODUCT NAME: Motion 3 Light Bath Vanity ITEM NUMBER: 27553WTPC Please consult a qualified electrician for hanging fixture and wiring. Caution: Xenon bulbs get very hot and may burn you. Always make sure bulbs are off for a minimum of 10 minutes before handling. Fixture may be dimmed using an electronic low voltage dimmer.
PAGE 2
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation Locate all hardware & components before discarding packaging 1.Remove mounting bracket from fixture and install to electrical box. Then wire fixture to wires in outlet box. Copper wire is for Ground. It can be installed up and down. 2.Attach back plate to mounting bracket and tighten ball nuts so fixture meets wall. 3.Install 3 max 40W G9 bulb into socket. 4.Thread glass onto cup.