Owner manual

UG_1x22_043 V.22 bis Linux Softmodem for 73M1x22 MicroDAA User Guide
Rev. 1.5 19
@L[n] Set Lease Line Operation
Lease line operation is designated by S89 bit 2
n = 1 Sets lease line bit
n = 0 Clears lease line bit
@Z Escape to OS
Terminates the softmodem application gracefully and goes to Linux prompt.
To return to Softmodem application from the linux prompt, type “tsc_1922_CRLF” from the
root directory.
+++ Escape Sequence
During a data connection, the escape command (+++) returns you to Command state
without
terminating the data connection so you can enter AT commands. The TSC
Softmodem supports the TIES (Timing Independent Escape Sequence) escape, not the
patented Hayes escape. The +++ must be followed by a valid AT command for the escape
to be recognized. If a non-
AT command follows the +++, the modem will return to the data
mode. Giving the TSC Softmodem a “+++AT” is also valid for escaping to the on-
line
command state.