Owner manual

Secure Microcontroller User’s Guide
36 of 187
Power Control Register
PCON, 087H
D7
D6
D5
D4
D3
D2
D1
D0
SMOD
POR
PFW
WTR
EPFW
EWT
STOP
IDL
RW-0
RT-*
R-*
R-*
RW-0
RT-*
RT-0
RW-0
R = Unrestricted Read Access, W = Unrestricted Write Access, T = Timed-access Write Only, n = Value after Reset, * = Special: see description
PCON.7 SMOD
Double Baud Rate When set to 1, the baud rate is doubled when the serial port is being used in modes
1, 2, or 3.
PCON.6
POR
Power-On Reset Indicates that the previous reset was initiated during a power-on sequence. This bit
is cleared to 0 when power-on reset occurs, and remains 0 until it is set to 1 by
software.
PCON.5 PFW
Power-Fail Warning Indicates that a potential power failure is in progress. Set to 1 whenever V
CC
is
below the V
PFW
threshold. Cleared to 0 immediately following a read operation of
the PCON register. Once set, it remains set until the read operation occurs,
regardless of activity on V
CC
. After PFW is cleared by a read, it returns to 1 if V
CC
< V
PFW
. This bit is cleared to a 0 during a power-on reset.
PCON.4 WTR
Watchdog Timer Reset Set to 1 following a watchdog timer timeout. If WTR is enabled, it indicates the
cause of the reset. Cleared to 0 immediately following a read of the PCON
register. This bit is set to 1 after a WTR and cleared to 0 on a power-on reset.
Remains unchanged during other types of resets.
PCON.3 EPFW
Enable Power-Fail Interrupt Enables (EPFW = 1) or disables (EPFW = 0) the power-fail interrupt.
PCON.2 EWT
Enable Watchdog Timer Enables (EWT = 1) or disables (EWT = 0) the WTR. This bit is cleared to 0 on a
no-V
LI
power-on reset and remains unchanged during other types of reset.
PCON.1 STOP
Stop Used to invoke the stop mode. When set to 1, program execution terminates
immediately and stop mode operation commences. Cleared to 0 when program
execution resumes following a hardware reset.
PCON.0 IDL
Idle Used to invoke the idle mode. When set to 1, program execution is halted and
resumes when the idle bit is cleared to 0 following an interrupt or a hardware reset.