Datasheet

MAX4506/MAX4507
Fault-Protected, High-Voltage
Signal-Line Protectors
4 _______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS—Single Supply (continued)
(V+ = +12V, V- = -0V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at T
A
= +25°C.) (Note 3)
R
L
= 10kΩ, V
IN_
= +25V± Fault Recovery Time (Note 5) +25°C µs
10
V
2.5
T
A
M
V+
CONDITIONS
Power-Supply Range
R
L
= 10kΩ, V
IN_
= +25V
± Fault Output Turn-On Delay
Time (Note 5)
ns+25°C
C, E, M
+9 +36
V
IN_
= 25V
PARAMETER SYMBOL MIN TYP MAX UNITS
Output Clamp Current,
Supply On
I
OUT_
+25°C
3 5.5 10
mA
µA
µA
M
-10 +10
Input Signal-Path Leakage
Current, Supply Off (Note 9)
I
IN_
-10 +10
V
IN_
= ±40V
+25°C
Input Signal-Path Leakage
Current, Supply On (Note 9)
I
IN_
C, E
-10 +10
µA
+25°C
C, E
M
+25°C
C, E
M
V
IN_
= +12VI+
925
µA
30
40
17 40
60
Power-Supply Current
80
MAX4507
MAX4506
Applies with power off
V
IN_
= ±25V, V
OUT_
= 0
+25°C
C, E
-10 +10
C, E, M
µA
-40 +40
-1 0.2 +1
-1 0.2 +1
Applies with power on C, E, M
-36 +36
V
Fault-Protected Analog Signal
Range (Notes 4, 5, 9)
V
IN_
V
IN_
= ±25V
Output Clamp Resistance,
Supply On
R
OUT_
+25°C
1.0 2.5
kΩ
Note 3: The algebraic convention is used in this data sheet; the most negative value is shown in the minimum column.
Note 4: See Fault-Free Analog Signal Range vs. Supply Voltages graph in the Typical Operating Characteristics.
Note 5: Guaranteed by design.
Note 6: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
Note 7: Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at T
A
= +25°C.
Note 8: Leakage testing for single-supply operation is guaranteed by testing with dual supplies.
Note 9: Guaranteed by testing with dual supplies.
POWER SUPPLY
FAULT PROTECTION