Datasheet
Supply Voltage (V
DD
to V
SS
) ................................................6V
All Other Pins ...................................(V
SS
- 0.3V) to (V
DD
+ 0.3V)
Output Short-Circuit Duration to V
DD
or V
SS
(Note 1) ...............10s
Continuous Power Dissipation (Multilayer, TA = +70°C)
5-Pin SC70 (derate 3.1mW/°C above +70°C) ..............247mW
5-Pin SOT23 (derate 3.9mW/°C above +70°C)............313mW
6-Pin SC70 (derate 3.1mW/°C above +70°C) ..............245mW
6-Pin SOT23 (derate 13.4mW/°C above +70°C)........1072mW
6-Pin Thin µDFN (derate 2.1mW/°C above +70°C)...170.2mW
6-Bump UCSP (derate 3.9mW/°C above +70°C) .....308.3mW
8-Pin SOT23 (derate 5.1mW/°C above +70°C).........408.2mW
8-Pin µMAX
®
(derate 4.8mW/°C above +70°C) .......387.8mW
10-Pin µMAX (derate 8.8mW/°C above +70°C) .......707.3mW
10-Bump UCSP (derate 5.6mW/°C above +70°C) .....448.7mW
14-Pin SO (derate 11.9mW/°C above +70°C) ..........952.4mW
14-Pin TSSOP (derate 10mW/°C above +70°C) ......796.8mW
Operating Temperature Range .........................-40°C to +125°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature
(excluding 6 and 10 UCSP, soldering, 10s) ................+300°C
Soldering Temperature (reflow) .......................................+260°C
Note 1: Package power dissipation should also be observed.
(V
DD
= 2.7V, V
SS
= 0V, V
CM
= V
DD/2
, V
OUT
= (V
DD/2
), R
L
= ∞ connected to (V
DD/2
), V
SHDN
= V
DD
, T
A
= +25°C, unless otherwise
noted.) (Note 2)
μMAX is a registered trademark of Maxim Integrated Products, Inc.
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Operating Supply Voltage
Range
V
DD
Inferred from PSRR test 2.7 5.5 V
Input Offset Voltage V
OS
0.85 ±6 mV
Input Bias Current (Note 4) I
B
V
CM
= V
SS
to V
DD
1 pA
Input Offset Current I
OS
V
CM
= V
SS
to V
DD
50 pA
Input Resistance R
IN
1000 MΩ
Common-Mode Input
Voltage Range
V
CM
Inferred from CMRR test V
SS
V
DD
V
Common-Mode Rejection
Ratio
CMRR V
SS
< V
CM
< V
DD
52 70 dB
Power-Supply Rejection
Ratio
PSRR V
DD
= 2.7V to 5.5V 73 85 dB
Shutdown Output
Impedance
R
OUT
V
SHDN
= 0V (Note 3) 10 Ω
Output Voltage in Shutdown V
OUT(SHDN)
V
SHDN
= 0V, R
L
= 200Ω (Note 3) 68 mV
Large-Signal Voltage Gain A
VOL
V
SS
+ 0.20V <
V
OUT
< V
DD
-
0.20V
R
L
= 100kΩ 100
dBR
L
= 2kΩ 85 98
R
L
= 200Ω 74 80
Output Voltage Swing V
OUT
R
L
= 32Ω
V
DD
- V
OH
400 500
mV
V
OL
- V
SS
360 500
R
L
= 200Ω
V
DD
- V
OH
80 120
V
OL
- V
SS
70 120
R
L
= 2kΩ
V
DD
- V
OH
8 14
V
OL
- V
SS
7 14
MAX4230–MAX4234 High-Output-Drive, 10MHz, 10V/μs,
Rail-to-Rail I/O Op Amps with Shutdown in SC70
www.maximintegrated.com
Maxim Integrated
│
2
Absolute Maximum Ratings
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these
or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect
device reliability.
DC Electrical Characteristics