Datasheet
Table 22. Register 6 (A3:A0 = 0110)
DATA BIT RECOMMENDED DESCRIPTION
D13 0 Set to recommended value.
D12:D11 00
Tx I/Q Calibration LO Leakage and Sideband Detector Gain-Control Bits. D12:D11 = 00: 9dB;
01 19dB; 10: 29dB; 11: 39dB.
D10:D7 0000 Set to recommended value.
D6 1
Power-Detector Enable in Tx Mode. Set to 1 to enable the power detector or set to 0 to
disable the detector.
D5:D2 1000 Set to recommended value.
D1 0
Tx Calibration Mode. Set to 1 to place the device in Tx calibration mode or 0 to place the
device in normal Tx mode when RXTX is set to 1 (see Table 32).
D0 0
Rx Calibration Mode. Set to 1 to place the device in Rx calibration mode or 0 to place the
device in normal Rx mode when RXTX is set to 0 (see Table 32).
Table 23. Register 7 (A3:A0 = 0111)
BIT RECOMMENDED DESCRIPTION
D13:D12 01
Receiver Highpass Corner Frequency Setting for RXHP = 0. Set to 00 for 100Hz, X1 for 4kHz,
and 10 for 30kHz.
D11:D6 000000 Set to recommended value.
D5:D3 100
Transmitter Lowpass Filter Corner Frequency Fine Adjustment (Relative to Coarse Setting).
See Table 9. Bits D1:D0 in A3:A0 = 1000 provide the lowpass filter corner coarse adjustment.
D2:D0 010
Receiver Lowpass Filter Corner Frequency Fine Adjustment (Relative to Coarse Setting). See
Table 6. Bits D1:D0 in A3:A0 = 1000 provide the lowpass filter corner coarse adjustment.
Table 24. Register 8 (A3:A0 = 1000)
BIT RECOMMENDED DESCRIPTION
D13 1 Set to recommended value.
D12 0
Enable Receiver Gain Programming Through the Serial Interface. Set to 1 to enable
programming through the 3-wire serial interface (D6:D0 in Register A3:A0 = 1011). Set to 0 to
enable programming in parallel through external digital pins (B7:B1).
D11 0 Set to recommended value.
D10 0
RSSI Operating Mode. Set to 1 to enable RSSI output independent of RXHP. Set to 0 to
disable RSSI output if RXHP = 0, and enable the RSSI output if RXHP = 1.
D9:D8 00
RS S I, P ow er D etector , or Tem p er atur e S ensor O utp ut S el ect. S et to 00 to enab l e the RS S I
outp ut i n r ecei ve m od e. S et to 01 to enab l e the tem p er atur e sensor outp ut i n r ecei ve and
tr ansm i t m od es. S et to 10 to enab l e the p ow er - d etector outp ut i n tr ansm i t m od e. S ee Tab l e 7.
D7:D2 001000 Set to recommended value.
D1:D0 01
Receiver and Transmitter Lowpass Filter Corner Frequency Coarse Adjustment. See Tables 4
and 7.
28
Maxim Integrated
2.4GHz to 2.5GHz 802.11g/b RF Transceiver, PA,
and Rx/Tx/Antenna Diversity Switch
MAX2830