Datasheet

MAX2121
Complete Direct-Conversion L-Band Tuner
2
ABSOLUTE MAXIMUM RATINGS
DC ELECTRICAL CHARACTERISTICS
(MAX2121 Evaluation Kit: V
CC_
= +3.13V to +3.47V, f
XTAL
= 27MHz, T
A
= -40°C to +85°C, V
GC1
= +0.5V (max gain), default register
settings except BBG[3:0] = 1011. No input signals at RF, baseband I/Os are open circuited. Typical values measured at V
CC
=
+3.3V, T
A
= +25°C, unless otherwise noted.) (Note 1)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V
CC_
to GND .........................................................-0.3V to +3.9V
All Other Pins to GND.................................-0.3V to (V
CC
+ 0.3V)
RF Input Power: RFIN .....................................................+10dBm
BYPVCO, CPOUT, XTAL, REFOUT, IOUT_, QOUT_ , IDC_,
QDC_ to GND Short-Circuit Protection...............................10s
Continuous Power Dissipation (T
A
= +70°C)
TQFN (derate 34.5mW/°C above +70°C) ......................2.75W
Operating Temperature Range .............................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10s) .................................+300°C
Soldering Temperature (reflow) .......................................+260°C
PARAMETER CONDITIONS MIN TYP MAX UNITS
SUPPLY
Supply Voltage (V
CC_
) 3.13 3.3 3.47 V
Receive mode, bit STBY = 0 148 200
Supply Current
Standby mode, bit STBY = 1 3
mA
ADDRESS SELECT INPUT (ADDR)
Digital Input-Voltage High, V
IH
2.4 V
Digital Input-Voltage Low, V
IL
0.5 V
Digital Input-Current High, I
IH
50 µA
Digital Input-Current Low, I
IL
-50 µA
ANALOG GAIN-CONTROL INPUT (GC1)
Input Voltage Range Maximum gain = 0.5V 0.5 2.7 V
Input Bias Current -50 +50 µA
VCO TUNING VOLTAGE INPUT (TUNEVCO)
Input Voltage Range 0.4 2.3 V
2-WIRE SERIAL INPUTS (SCL, SDA)
Clock Frequency 400 kHz
Input Logic-Level High
0.7 x
V
CC
V
Input Logic-Level Low
0.3 x
V
CC
V
Input Leakage Current Digital inputs = GND or V
CC
±0.1 ±1 µA
2-WIRE SERIAL OUTPUT (SDA)
Output Logic-Level Low I
SINK
= 1mA (Note 2) 0.4 V
CAUTION! ESD SENSITIVE DEVICE