Datasheet

MAX197
Multi-Range (±10V, ±5V, +10V, +5V),
Single +5V, 12-Bit DAS with 8+4 Bus Interface
_______________________________________________________________________________________ 7
______________________________________________________________Pin Description
Digital GroundDGND28
+5V Supply. Bypass with 0.1µF capacitor to AGND.V
DD
27
INT goes low when conversion is complete and output data is ready.INT
24
Bandgap Voltage-Reference Output/External Adjust Pin. Bypass with a 0.01µF capacitor to AGND. Connect
to V
DD
when using an external reference at the REF pin.
REFADJ25
Reference Buffer Output/ADC Reference Input. In internal reference mode, the reference buffer provides a
4.096V nominal output, externally adjustable at REFADJ. In external reference mode, disable the internal
buffer by pulling REFADJ to V
DD
.
REF26
Three-State Digital I/O. D2 output (HBEN = low), D10 output (HBEN = high).D2/D1012
Three-State Digital I/O. D1 output (HBEN = low), D9 output (HBEN = high).D1/D913
Three-State Digital I/O. D0 output (HBEN = low), D8 output (HBEN = high). D0 = LSB.D0/D814
Analog GroundAGND15
Analog Input ChannelsCH0–CH716–23
Used to multiplex the 12-bit conversion result. When high, the 4 MSBs are multiplexed on the data bus;
when low, the 8 LSBs are available on the bus.
HBEN5
Shutdown. Puts the device into full power-down (FULLPD) mode when pulled low.
SHDN
6
Three-State Digital I/OD7–D47–10
Three-State Digital I/O. D3 output (HBEN = low), D11 output (HBEN = high).D3/D1111
If CS is low, a falling edge on RD will enable a read operation on the data bus.RD
4
When CS is low, in the internal acquisition mode, a rising edge on WR latches in configuration data and starts an
acquisition plus a conversion cycle. When CS is low, in the external acquisition mode, the first rising edge on
WR starts an acquisition and a second rising edge on WR ends acquisition and starts a conversion cycle.
WR
3
PIN
Chip Select, active low.
CS
2
Clock Input. In external clock mode, drive CLK with a TTL/CMOS compatible clock. In internal clock mode,
place a capacitor from this pin to ground to set the internal clock frequency; f
CLK
= 1.56MHz typical with
C
CLK
= 100pF.
CLK1
FUNCTIONNAME
100kΩ
510kΩ
24kΩ
REFADJ
+5V
0.01µF
MAX197
Figure 1. Reference-Adjust Circuit
3kΩ
3kΩ
D
OUT
D
OUT
+5V
a. HIGH-Z TO V
OH
AND V
OL
TO V
OH
b. HIGH-Z TO V
OL
AND V
OH
TO V
OL
C
LOAD
C
LOAD
Figure 2. Load Circuits for Enable Time