Datasheet

JUMPER SHUNT POSITION DESCRIPTION
JU1
1-2 Disables channel A for the TDFN-EP (3mm x 3mm) package
Open* Enables channel A for the TDFN-EP (3mm x 3mm) package
JU2
1-2 Disables channel B for the TDFN-EP (3mm x 3mm) package
Open* Enables channel B for the TDFN-EP (3mm x 3mm) package
JU3
1-2 Disables channel A for the SO (3.9mm x 4.9mm) package
Open* Enables channel A for the SO (3.9mm x 4.9mm) package
JU4
1-2 Disables channel B for the SO (3.9mm x 4.9mm) package
Open* Enables channel B for the SO (3.9mm x 4.9mm) package
JU5
1-2
Disables channel A for the FMAX-EP (3mm x 3mm) package
Open*
Enables channel A for the FMAX-EP (3mm x 3mm) package
JU6
1-2
Disables channel B for the FMAX-EP (3mm x 3mm) package
Open*
Enables channel B for the FMAX-EP (3mm x 3mm) package
JU7
1-2 Disables channel A for the TDFN-EP (2mm x 3mm) package
Open* Enables channel A for the TDFN-EP (2mm x 3mm) package
JU8
1-2 Disables channel B for the TDFN-EP (2mm x 3mm) package
Open* Enables channel B for the TDFN-EP (2mm x 3mm) package
PART OUTA POLARITY OUTB POLARITY
MAX17600EVKIT# Inverting Inverting
MAX17601EVKIT# Noninverting Noninverting
MAX17602EVKIT# Inverting Noninverting
MAX17603EVKIT# Inverting Inverting
MAX17604EVKIT# Noninverting Noninverting
MAX17605EVKIT# Inverting Noninverting
_________________________________________________________________ Maxim Integrated Products 3
MAX17600–MAX17605 Evaluation Kits
Evaluate: MAX17600–MAX17605
Quick Start
Required Equipment
• MAX17600–MAX17605EVkit
• 4Vto14VDCpowersupply
Procedure
The EV kits are fully assembled and tested. Follow the
steps below to verify U1 board operation. Caution: Do
not turn on the power supply until all connections are
completed.
1) Verify that all jumpers are in their default positions, as
shown in Table 1.
2) Connect the positive terminal of the power supply to
the VDD1 PCB pad and the negative terminal to the
nearest GND PCB pad on the EV kit.
3) Set the VDD1 power supply to 14V and enable its
output.
4) Drive INA1 high and verify that the OUTA1 polarity is
according to Table 2.
5) Drive INB1 high and verify that the OUTB1 polarity is
according to Table 2.
6) Drive INA1 low and verify that the OUTA1 polarity is
according to Table 2.
7) Drive INB1 low and verify that the OUTB1 polarity is
according to Table 2.
8) Repeat accordingly for the other circuits.
Table 1. Jumper Descriptions (JU1–JU8)
Table 2. OUTA /OUTB Polarity vs. INA/INB Polarity
*Default position.