Datasheet

Evaluates: MAX17062
MAX17062 Evaluation Kit
2 _______________________________________________________________________________________
Component List (continued)
DESIGNATION QTY DESCRIPTION
D2, D4 2
250mA, 90V dual ultra-fast diodes
(SOT23)
Central Semiconductor CMPD1001S
LEAD FREE (Top Mark: L21)
Diodes Inc. BAV99 (300mA, 100V)
D3 0 Not installed, diode (SOT23)
JU1 1 2-pin header (0.1in centers)
JU2 0
Not installed, 3-pin header—short
(0.1in centers)
JU3 0
Not installed, 2-pin header—short
(0.1in centers)
L1 1
2.7µH ±20% power inductor
TOKO FDV0630-2R7 (27mΩ, 4.4A)
Sumida CDRH5D18BHPNP-2R7M
(65mΩ, 3.9A)
DESIGNATION QTY DESCRIPTION
R1 1 100kΩ ±5% resistor (0603)
R2 1 47kΩ ±5% resistor (0603)
R3 1 20kΩ ±1% resistor (0603)
R4 1 221kΩ ±1% resistor (0603)
R5 1 10Ω ±5% resistor (0603)
R6 0 Not installed, resistor (0603)
R7 1 0Ω ±5% resistor (0603)
U1 1
High-performance step-up
DC-DC controller (10 TDFN-EP*)
Maxim M AX 17062E TB+
— 1 Shunt
— 1 PCB: MAX17062 Evaluation Kit+
Component Suppliers
SUPPLIER PHONE WEBSITE
Central Semiconductor 631-435-1110 www.centralsemi.com
Diodes, Inc. 805-446-4800 www.diodes.com
Murata Electronics North America, Inc. 770-436-1300 www.murata-northamerica.com
Sumida Corp. 847-545-6700 www.sumida.com
TDK Corp. 847-803-6100 www.component.tdk.com
TOKO America, Inc. 847-297-0070 www.tokoam.com
Note: Indicate that you are using the MAX17062 when contacting these component suppliers.
Quick Start
Recommended Equipment
Before beginning, the following equipment is needed:
• +4.5V to +5.5V, 5A DC power supply (VIN)
• Voltmeter
Procedure
The MAX17062 EV kit is fully assembled and tested. Follow
these steps to verify board operation. Caution: Do not
turn on the power supply until all connections are
completed.
1) Verify that there is no shunt placed across jumper
JU1 to enable the MAX17062.
2) Connect the positive terminal of the DC power sup-
ply to the VIN pad. Connect the negative terminal of
the DC power supply to the PGND pad.
3) Turn on the +4.5V to +5.5V DC power supply and
verify that the step-up switching regulator output
(VOUT) is +15V.
4) Verify that the gate-on supply (VGON) is approxi-
mately +29V.
5) Verify that the gate-off supply (VGOFF) is approxi-
mately -15V.
* EP = Exposed pad.