Datasheet

18 Maxim Integrated
12-Channel/8-Channel, Flash-Configurable System
Managers with Nonvolatile Fault Registers
MAX16070/MAX16071
General-Purpose Inputs/Outputs
GPIO1 to GPIO8 are programmable general-purpose
inputs/outputs. GPIO1–GPIO8 are configurable as a
manual reset input, a watchdog timer input and output,
logic inputs/outputs, fault-dependent outputs. When pro-
grammed as outputs, GPIO_s are open drain or push-
pull. See Tables 8 and 9 for more detailed information on
configuring GPIO1 to GPIO8.
When GPIO1 to GPIO8 are configured as general-pur-
pose inputs/outputs, read values from the GPIO_ ports
through r1Eh and write values to GPIO_s through r3Eh.
Note that r3Eh has a corresponding flash register, which
programs the default state of a general-purpose output.
See Table 7 for more information on reading and writing
to the GPIO_.
Table 7. GPIO_ State Registers
Table 8. GPIO_ Configuration Registers
REGISTER
ADDRESS
FLASH
ADDRESS
BIT RANGE DESCRIPTION
1Eh —
[0] GPIO1 input state
[1] GPIO2 input state
[2] GPIO3 input state
[3] GPIO4 input state
[4] GPIO5 input state
[5] GPIO6 input state
[6] GPIO7 input state
[7] GPIO8 input state
3Eh 23Eh
[0] GPIO1 output state
[1] GPIO2 output state
[2] GPIO3 output state
[3] GPIO4 output state
[4] GPIO5 output state
[5] GPIO6 output state
[6] GPIO7 output state
[7] GPIO8 output state
REGISTER
ADDRESS
FLASH
ADDRESS
BIT RANGE DESCRIPTION
3Fh 23Fh
[2:0] GPIO1 configuration
[5:3] GPIO2 configuration
[7:6] GPIO3 configuration (LSB)
40h 240h
[0] GPIO3 configuration (MSB)
[3:1] GPIO4 configuration
[6:4] GPIO5 configuration
[7] GPIO6 configuration (LSB)
41h 241h
[1:0] GPIO6 configuration (MSB)
[4:2] GPIO7 configuration
[7:5] GPIO8 configuration