Datasheet
MAX1110/MAX1111
+2.7V, Low-Power, Multichannel,
Serial 8-Bit ADCs
_______________________________________________________________________________________ 7
______________________________________________________________Pin Description
16 SSTRB
Serial-Strobe Output. In internal clock mode, SSTRB goes low when the MAX1110/
MAX1111 begin the A/D conversion and goes high when the conversion is done.
In external clock mode, SSTRB pulses high for two clock periods before the MSB is
shifted out. High impedance when CS is high (external clock mode only).
20 V
DD
Positive Supply Voltage, 2.7V to 5.5V
18
CS
Active-Low Chip Select. Data is not clocked into DIN unless CS is low. When CS is
high, DOUT is high impedance. The voltage at CS can exceed V
DD
(up to 5.5V).
19 SCLK
Serial-Clock Input. Clocks data in and out of serial interface. In external clock mode,
SCLK also sets the conversion speed (duty cycle must be 45% to 55%). The voltage at
SCLK can exceed V
DD
(up to 5.5V).
17 DIN
Serial-Data Input. Data is clocked in at SCLK’s rising edge. The voltage at DIN can
exceed V
DD
(up to 5.5V).
12 REFOUT Internal Reference Generator Output. Bypass with a 1µF capacitor to AGND.
14 DGND Digital Ground
15 DOUT
Serial-Data Output. Data is clocked out on SCLK’s falling edge. High impedance when
CS is high.
13 AGND Analog Ground
10
SHDN
Three-Level Shutdown Input. Normally high impedance. Pulling SHDN low shuts the
MAX1110/MAX1111 down to 10µA (max) supply current; otherwise, the devices are
fully operational. Pulling SHDN high shuts down the internal reference.
11 REFIN
Reference Voltage Input for Analog-to-Digital Conversion. Connect to REFOUT to use
the internal reference.
5–8 CH4–CH7 Sampling Analog Inputs
1–4 CH0–CH3 Sampling Analog Inputs
+3V
3kΩ
C
LOAD
DGND
DOUT
C
LOAD
DGND
3kΩ
DOUT
a) High-Z to V
OH
and V
OL
to V
OH
b) High-Z to V
OL
and V
OH
to V
OL
Figure 1. Load Circuits for Enable Time
+3V
3kΩ
C
LOAD
DGND
DOUT
C
LOAD
DGND
3kΩ
DOUT
a) V
OH
to High-Z b) V
OL
to High-Z
Figure 2. Load Circuits for Disable Time
12
16
14
15
13
8
10
11
9
6
7
—
1–4
59 COM
Ground Reference for Analog Inputs. Sets zero-code voltage in single-ended mode.
Must be stable to ±0.5 LSB.
PIN
MAX1111
NAME FUNCTION
MAX1110