Datasheet

Evaluates: MAX11044–MAX11049
Stand-Alone
A user-supplied signal generator and logic analyzer
can be used to evaluate the MAX11046 without the on-
board DSP (U2). First disconnect the MAX11046 from
U2 by removing RN8, RN9, and RN10. Then connect all
necessary signals from the signal generator and logic
analyzer to connector J12. The MAX11046 pins are
connected to J12, as shown in Table 2.
MAX11046 Evaluation Kit
6 _______________________________________________________________________________________
* Default position.
Note: CH_ refer to MAX11046 and MAX11049 pin names only.
JUMPER
SHUNT
POSITION
DESCRIPTION
1-2* CH3 connected to BNC4 directly
2-3 CH3 shorted to ground
JU10
Open
CH3 connected to BNC4 through a
1kΩ resistor
1-2* CH4 connected to BNC5 directly
2-3 CH4 shorted to ground
JU11
Open
CH4 connected to BNC5 through a
1kΩ resistor
1-2* CH5 connected to BNC6 directly
2-3 CH5 shorted to ground
JU12
Open
CH5 connected to BNC6 through a
1kΩ resistor
JUMPER
SHUNT
POSITION
DESCRIPTION
1-2* CH6 connected to BNC7 directly
2-3 CH6 shorted to ground
JU13
Open
CH6 connected to BNC7 through a
1kΩ resistor
1-2* CH7 connected to BNC8 directly
2-3 CH7 shorted to ground
JU14
Open
CH7 connected to BNC8 through a
1kΩ resistor
Table 1. Jumper Configuration (continued)
PIN SIGNAL NAME
1D0
2D1
3D2
4D3
5D4
6D5
7D6
8D7
9D8
10 D9
11 D10
12 D11
PIN SIGNAL NAME
13 D12
14 D13
15 D14
16 D15
17, 18 GND
19 WRB
20 CSB
21 RDB
22 SHDN
23 EOCB
24 CONVST
Table 2. MAX11046 Breakout to J12