Datasheet

MAX1060/MAX1064
Digital Interface
Input (control byte) and output data are multiplexed on a
tri-state parallel interface. This parallel interface (I/O) can
easily be interfaced with standard µPs. Signals CS, WR,
and RD control the write and read operations. CS repre-
sents the chip-select signal, which enables a µP to
address the MAX1060/MAX1064 as an I/O port. When
high, CS disables the CLK, WR, and RD inputs and
forces the interface into a high-impedance (high-Z) state.
Input Format
The control byte is latched into the device on pins D7–
D0 during a write command. Table 2 shows the control
byte format.
Output Format
The output format for the MAX1060/MAX1064 is binary in
unipolar mode and two’s complement in bipolar mode.
When reading the output data, CS and RD must be low.
When HBEN = 0, the lower 8 bits are read. With HBEN =
1, the upper 2 bits are available and the output data bits
D7–D2 are set either low in unipolar mode or to the value
of the MSB in bipolar mode (Table 5).
400ksps, +5V, 8-/4-Channel, 10-Bit ADCs
with +2.5V Reference and Parallel Interface
14 ______________________________________________________________________________________
Table 2. Control Byte Format
Table 4. Channel Selection for Pseudo-Differential Operation (SGL/DIF = 0)
Table 3. Channel Selection for Single-Ended Operation (SGL/DIF = 1)
*Channels CH4–CH7 apply to MAX1060 only.
*Channels CH4
–CH7 apply to MAX1060 only.
A1 CH0
0 +0 -0
A0
0 -1
CH2 CH4*
+0
1 0 + -
CH3
0
CH1 CH7*CH6*
1
CH5*
1 - +0
0 0
A2
+ -1
0 1 - +1
1 0 -1
1 1
+
1 +-
A1 CH0
0 +00
A0
0 1
CH2 CH4*
+0
1 0 +
CH3
-
0
CH1 CH7*
-
CH6*
-
COM
1
CH5*
1 + -0
0 0
A2
+1
0 1 +1
-
-
1 01
1 1
+
1
-
+ -
D6 D4
PD0
SGL/DIF
ACQMOD A2 A0A1
UNI/BIP
PD1
D5 D2 D0 (LSB)D1D3D7 (MSB)