Users Guide: Network Microcontroller Supplement User Manual

High-Speed Microcontroller User’s
Guide: Network Microcontroller
Supplement
REVISION
NUMBER
REVISION
DATE
SECTION
NUMBER
DESCRIP TION
PAGES
CHANGED
0 12/02 — Initial release. —
1 1/9/03 6 Replaced Figure 6-5. 90
2 3/5/03 11 New paragraph added to the Divi de-by-13 O ption section to explain the options’ usefulness. 107
4
CAN 0 Status Register ( C0S ), Bit 6 (E C96/128): D escription corrected to: "EC96/128 = 0 indicated
that the current transm it error counter and receive er ror counter both have an error count of less
than 97." (previously 96)
37
CAN 0 Standard Global Mask Register 1 (C0SG M1): Last sentence clar ified to show that "A read
of these bits wi ll return a 0, wr ites are ignored."
126
CAN 0 Message Center y Arb itration Register 3 (C0 MyAR3): The second sentence for the
Reserved bits was clarified to read "These bits can be modified by the appl ication software."
129
3 11/12/03
19
Second paragraph in the Receiving/Responding to Remote Frame Requests section was moved t
o
end of Transmitting Remote Frame Requests section for clarif
ication.
139
4 2/5/04 23
Asynchronous TCP/IP Maintenance Functions section: Cor rectio
n for wos_cr it_count (in
entercritsection and leavecritsection). Located at address 68h, not 6Bh.
195
5 2/18/04 23 Ser ial Loader section: Second sentence changed to reflect that an external reset (RST = 1). 173
Added information on D S80C410/DS80C411. Various pages
6 4/13/05 —
Changed name of document to Network Microcontroller Supple ment. All
7 10/05 20
Normal ize section: Added sent
ence to description saying the normalize function can only be used
on nonzero values.
173
4 Cor rected typo for T MOD b it 2 description. 31
19 Up dated Figure 19-11 and moved it to page 168. 168
8 8/06
23 Added crystal speeds to Autobaud-Rate Detection section. 195
9 7/07 4 C orrected description of P5CNT SFR to reflect its presence on the DS80C411. 47
10 10/07 4
Corrected ty pos; added descri ption to MCON1.7 and MCON 1.6 defining that the bit is undefined
on the DS80C400.
25, 85
11 3/08 23 Added C RC -16 polynomial to Command Sum mary C begin address. 195
12 9/08 6 Replaced Figure 6-10 (incorrect figure inserted in er ror. ) 107
REVISION HISTORY
221
Maxim Integrated 160 Rio Robles, San Jose, CA 95134 USA 1-408-601-1000
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied.
Maxim reserves the right to change the circuitry and specifications without notice at any time. The parametric values (min and max limits) shown in the Electrical
Characteristics table are guaranteed. Other parametric values quoted in this data sheet are provided for guidance.
©
 Maxim Integrated
The Maxim logo and Maxim Integrated are trademarks of Maxim Integrated Products, Inc.