Datasheet

DS3882
Dual-Channel Automotive CCFL Controller
2 _____________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
RECOMMENDED OPERATING CONDITIONS
(T
A
= -40°C to +105°C)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Voltage Range on V
CC
, SDA, and
SCL Relative to Ground.....................................-0.5V to +6.0V
Voltage Range on Leads Other than V
CC
, SDA, and
SCL ......................-0.5V to (V
CC
+ 0.5V), not to exceed +6.0V
Continuous Power Dissipation (T
A
= +70°C)
TSSOP (derate 12.8mW/°C above +70°C) .............1025.6mW
Operating Temperature Range .........................-40°C to +105°C
EEPROM Programming Temperature Range .........0°C to +85°C
Storage Temperature Range .............................-55°C to +125°C
Lead Temperature (soldering, 10s) .................................+300°C
Soldering Temperature (reflow) .......................................+260°C
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Supply Voltage V
CC
(Note 1) 4.75 5.25 V
Input Logic 1 V
IH
2.0
V
CC
+ 0.3
V
Input Logic 0 V
IL
-0.3 1.0 V
SVML/H Voltage Range V
SVM
-0.3
V
CC
+
0.3
V
BRIGHT Voltage Range V
BRIGHT
-0.3
V
CC
+
0.3
V
LCM Voltage Range V
LCM
(Note 2) -0.3
V
CC
+
0.3
V
OVD Voltage Range V
OVD
(Note 2) -0.3
V
CC
+
0.3
V
Gate-Driver Output Charge
Loading
Q
G
20 nC
ELECTRICAL CHARACTERISTICS
(V
CC
= +4.75V to +5.25V, T
A
= -40°C to +105°C.)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Supply Current I
CC
G
A
, G
B
l oad ed w i th 600p F, 2 channel s acti ve 12 mA
Input Leakage (Digital Pins) I
L
-1.0 +1.0 µA
Power-Down Current I
PDN
2mA
Output Leakage (SDA, FAULT)I
LO
High impedance -1.0 +1.0 µA
Low-Level Output Voltage
(LSYNC, PSYNC)
V
OL
I
OL
= 4mA 0.4 V
V
OL1
I
OL1
= 3mA 0.4
Low-Level Output Voltage
(SDA, FAULT)
V
OL2
I
OL2
= 6mA 0.6
V
Low-Level Output Voltage
(GA, GB)
V
OL3
I
OL3
= 4mA 0.4 V
High-Level Output Voltage
(LSYNC, PSYNC)
V
OH
I
OH
= -1mA 2.4 V