Datasheet

____________________________________________________ DS34T101, DS34T102, DS34T104, DS34T108
232 of 366
Register Name :
RSAOI1, RSAOI2, RSAOI3
Register Description:
Receive Signaling All-Ones Insertion Registers (T1 Mode Only)
Register Address:
base address + 0x0E0, 0x0E4, 0x0E8
Bit # 7 6 5 4 3 2 1 0
RSAOI1 CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1
RSAOI2 CH16 CH15 CH14 CH13 CH12 CH11 CH10 CH9
RSAOI3 CH24 CH23 CH22 CH21 CH20 CH19 CH18 CH17
Note: These registers have alternate definitions for E1 mode. See E1RIDR25-27.
Bits 7
to 0 (x3): Rx Signaling All-Ones Insertion Enable for Channels 1 to 24 (CH1 to CH24). Setting any of
the CH1 through CH24 bits in these registers causes signaling data on RSER to be replaced with logic ones for
those channels The RSIG signal continues to report the signaling data actually received. Note that this feature
must be enabled by setting RSIGC.RFS
A1=1. See Section 10.11.3.2.
0 = Do not affect the signaling data on RSER for this channel
1 = Replace the signaling data for this channel on RSER with all ones
Register Name :
RDMWE1-T1, RDMWE2-T1, RDMWE3-T1
Register Description:
Receive Digital Milliwatt Enable Registers (T1 Mode Only)
Register Address:
base address + 0x0F0, 0x0F4, 0x0F8
Bit # 7 6 5 4 3 2 1 0
RDMWE1-T1 CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1
RDMWE2-T1 CH16 CH15 CH14 CH13 CH12 CH11 CH10 CH9
RDMWE3-T1 CH24 CH23 CH22 CH21 CH20 CH19 CH18 CH17
Note: These registers have alternate definitions for E1 mode. See E1RIDR29-31.
Note: These registers are only used in T1 mode. The RDMWE1-E1 – RDMWE4-E1 regi
sters are used in E1 mode.
Bits 7 to 0 (x3): T1 Rx Digital Milliwatt Enable for Channels 1 to 24 (CH1 to CH24). Register bit RCR3.uALAW
spe
cifies whether u-law or A-law coding is used for the digital milliwatt code. See section 10.11.13.
0 = Do n
ot affect the Rx data associated with this channel
1 = Replace the Rx data associated with this channel with digital milliwatt code