Datasheet

DS17285/DS17287/DS17485/DS17487/DS17885/DS17887
Real-Time Clocks
_____________________________________________________________________ 9
Pin Description (continued)
PIN
24 28
NAME FUNCTION
21 3 RCLR
Active-Low RAM Clear Input. This pin is used to clear (set to logic 1) all the 114 bytes of
general-purpose RAM but does not affect the RAM associated with the real time clock or
extended RAM. RCLR may be invoked while the part is powered from any supply. The
RCLR function is designed to be used via a human interface (shorting to ground manually
or by a switch) and not to be driven with external buffers. This pin is internally pulled up. Do
not use an external pullup resistor on this pin.
22 4 V
BAUX
Auxiliary Battery Input. Required for kickstart and wake-up functions. This input also
supports clock/calendar and user RAM if V
BAT
is at lower voltage or is not used. A standard
+3V lithium cell or other energy source can be used. Diodes placed in series between
V
BAUX
and the battery may prevent proper operation. UL recognized to ensure against
reverse charging current when used with a lithium battery (www.maxim-ic.com/qa/info/ul/
).
For 3V V
CC
operation, V
BAUX
must be held between +2.5V and +3.7V. For 5V V
CC
operation,
V
BAUX
must be held between +2.5V and +5.2V. If V
BAUX
is not used it should be grounded
and the auxiliary-battery-enable bit bank 1, register 4BH, should = 0.
23 5 SQW
Square-Wave Output. When V
CC
rises above V
PF
, bits DV1 and E32k are set to 1. This
condition enables a 32kHz square-wave output. A square wave is output if either SQWE = 1
or E32k = 1. If E32k = 1, then 32kHz is output regardless of the other control bits. If E32k =
0, then the output frequency is dependent on the control bits in Register A. The SQW pin
can output a signal from one of 13 taps provided by the 15 internal divider stages of the
RTC. The frequency of the SQW pin can be changed by programming Register A, as shown
in Table 3. The SQW signal can be turned on and off using the SQWE bit in Register B or the
E32k bit in extended register 4Bh. A 32kHz square wave is also available when V
CC
is less
than V
PF
if E32k = 1, ABE = 1, and voltage is applied to the V
BAUX
pin. When disabled,
SQW is high impedance when V
CC
is below V
PF
.
24 6, 7 V
CC
DC Power Pin for Primary Power Supply. When V
CC
is applied within normal limits, the
device is fully accessible and data can be written and read. When V
CC
is below V
PF
reads
and writes are inhibited.
2, 3, 16,
20
(DS17x87
only)
11, 18 N.C. No Connection