Datasheet

DG300(A)/DG301(A)/DG302(A)/DG303(A)
Applications Information
All DG300 family switches will operate with ±5V to ±15V
power supplies. They can also be used with single-ended
power supplies ranging from +10V to +30V where the V-
terminal is connected to ground. In either case, analog
signals ranging from V+ to V- can be switched.
The on-resistance variation with analog signal and supply
voltage is shown in the Typical Operating Characteristics.
The temperature coefficient of R
ON
is typically 0.5%/°C.
Typical on-resistance matching from channel to chan-
nel is 10%. In addition, Table 1 outlines some typical
parameters for single-supply operation.
The charge injection test circuit is shown in Figure 1.
Table 2 lists the typical injected charge for DG300 series
switches with various input voltages.
TTL Compatible CMOS Analog Switches
6 _______________________________________________________________________________________
Table 1. Typical Single Supply Parameters
V+ SUPPLY VOLTAGE (V- = 0V)
PARAMETER
+10V +15V +20V +30V
t
ON
190ns 150ns 110ns 70ns
Switching Time (R
L
= 1kΩ)
t
OFF
40ns 40ns 40ns 40ns
V
SIGNAL
= +1V 71Ω 51Ω 42Ω 31Ω
V
SIGNAL
= V+ / 2 77Ω 54Ω 43Ω 30ΩOn-Resistance
V
SIGNAL
= V+ 84Ω 63Ω 54Ω 43Ω
Input Logic Levels 0.8V, 4.0V 0.8V, 4.0V 0.8V, 4.0V 0.8V, 4.5V
Table 2. Charge Injection (±15V Supplies)
ANALOG INPUT (V) INJECTED Q (pC)
+10 4
+5 8
012
-5 8
-10 5
Chip Topography
DIE PAD
DG300
DG300A
DG301
DG301A
DG302/DG303
DG302A/DG303A
a N.C. N.C. S3
bD1D1 D3
cN.C.S1 D1
dS1N.C. S1
e IN1 IN1 IN1
f N.C. N.C. N.C.
g GND GND GND
hV-V- V-
i IN2 N.C. IN2
jS2N.C. S2
k N.C. N.C. D2
lD2S2 D4
mN.C.D2 S4
nV+V+ V+
banm
l
k
j
c
d
efgh i
0.108"
2.74mm
0.106"
2.69mm