Getting Started Guide for LX9 and Nexys3 User Manual

Analog Essentials Getting Started Guide
10
For LX9 and Nexys-3
4. Using Xilinx SDK/XMD to download and run executable file (.elf) on the Microblaze.
a. Click the XMD Console tab if it isn’t already showing, as shown below.
b. At the XMD% prompt at the bottom of the XMD console, issue the following commands.
1. Use “pwd” and “cd” to navigate to the following directory:
C:\designs\maxim\v1_4\sdkWorkspace\maximPMOD\Debug
2. connect mb mdm
3. dow maximPMOD.elf
4. run
c. At this point, the application will be running on the Microblaze and the USB UART/Hyperterminal should
show a menu like the one below. This is the top level menu for the module example programs.