User Manual

UG_2901CE_027 73M29 01CE AT Command User Guide
Rev. 2.0 43
4.4.91 S90 – RTS to CTS Turn-around Delay
(Default = 2)
When the N0 command ha s bee n issued, register S90 defines the time interval between an OFF to ON
transition of RTS and when the modem turns CTS ON. The S90 setting applies to Synchronous modes
only.
Range is 1 to 254 (X 10ms).
RTS
CTS
RTS/CTS
delay
4.4.92 S91 – Call Progress Transmit Level
(Default = 90)
S91 determines the maximum value sen t to the DAC when sending call progress tone s. Range is 60 to
127.
4.4.93 S92 – Bit Mapped Register
(Default = 04h)
Bit 0 0 = Bell202 / V.23 receiver optimized for flat line.
1 = Bell202 / V.23 receiver optimized for 3002A line (unnecessary in versions 2901CL.01.36 and
later).
Bit 1 0 = Disables DTMF boo st
1 = Enables DTMF boost (Sets VREF to 2.25V and TXboost when usin g 5V power supply).
Bit 2 0 = Disables Pulse dial.
1 = Enables Pulse dial (default).
Bit 3 0 = No Imprecise Tones detected (last t one)
1 = Last value before imprecise tones went off.
Bit 4 Ring Bounce
Bit 6 0 = ITU answer tone 180 Degrees Phase Reversal disabled.
1 = For ITU answer tone, 180 Degre es Phase Reversal will occur every 450ms.
Bit 7 0 = Does not preserve the user changes to the DSP filters between connections (default).
1 = Preserves the user changes to the DSP filters be tween connections.
4.4.94 S93 – Ring Interval Register
(Default = 20)
The value in this register sets the duration of the minimum ring interval in units of 10ms. Range is 1 to
254.