User`s manual

Maxiflex T2 CPU User Manual 47 -© Omniflex
UMM124XBR04.pdf
DIT Number Description
Set this register to 4000 to enable the User I/O Slot Address Table.
Set to this register to 0 to disable the User I/O Slot Address Table and revert to the full
addressing scheme.
64081 User Start Address for I/O Slot 2
64082 User Start Address for I/O Slot 3
64083 User Start Address for I/O Slot 4
64084 User Start Address for I/O Slot 5
64085 User Start Address for I/O Slot 6
64086 User Start Address for I/O Slot 7
64087 User Start Address for I/O Slot 8
64088 User Start Address for I/O Slot 9
64089 User Start Address for I/O Slot 10
64090 User Start Address for I/O Slot 11
64091 User Start Address for I/O Slot 12
64092 User Start Address for I/O Slot 13
64093 User Start Address for I/O Slot 14
64094 User Start Address for I/O Slot 15
64095 RESERVED
64096 RESERVED
64097 Programmer’s Global Address
This register sets the Global ID of the programmer PC or Laptop so that it is possible to
remotely program other devices connected to the network port of the local CPU via the
Programming Port. This value is usually set to 254 as a default but may be changed by
the user if desired.
64098
RESERVED
64099 64100 Serial Port Configuration
64099
RTS/CTS Timeout
If RTS/CTS handshaking is enabled, then the transmitter will assert RTS when it is
ready to transmit. If CTS is asserted before the timeout period in this register, then
transmission will commence. If CTS is not asserted, then the transmission will be
aborted. Handshaking is enabled by setting bit 12 of register 64100.