User`s manual

Maxiflex T2 CPU User Manual 14 -© Omniflex
UMM124XBR04.pdf
If the I/O module configuration does not match the actual I/O modules installed, then this LED will
flash.
If no I/O modules are configured for the rack then the I/O OK LED will remain off.
The RUN LED will only turn ON at first power up if the CPU has a user application installed set to
begin operating at startup. When shipped from the factory, there is no user application installed
and the LED will remain OFF.
Note that if the BATT LED is ON at this time then check that the battery jumper has been inserted
correctly (refer to Section 4. Installation). If the jumper appears to be correct and the BATT LED
is still ON, then the battery level is low and the battery needs to be replaced. Please consult your
OMNIFLEX distributor to arrange battery replacement.