User`s manual

Maxiflex T2 CPU User Manual 11 -© Omniflex
UMM124XBR04.pdf
2. Installing the T2 CPU
2.1 Connecting the Internal Battery
Before installing the CPU, the battery jumper must be inserted to connect the internal battery
supply in the CPU. The CPU is shipped from the factory without the jumper connected to
preserve the battery life.
The battery jumper can be found at the base of the Maxiflex Bus connector at the rear of the CPU
module. Use long nose pliers or tweezers to correctly place the jumper over the posts.
2.2 Installing the T2 CPU on the Maxiflex base
Install the T2 CPUs into the CPU position ONLY of a Maxiflex Base. CPU’s must only be installed
and removed from the base with the power off.
Refer to the Maxiflex bases General Instructions for more detail on base layout, module insertion
and module removal. Please refer to Figure 2.1 for the CPU position.
Figure 2.1: Layout of the 7I/O Master Base