User Manual

CHAPTER 3
NETWORKS, COMMUNICATIONS AND CONNECTIONS
Product User Guide 19
The next window presented will give one the option of changing the installation folder and displays the hard drive space available and required for
the installation.
Click next to proceed.
The installation wizard will install the necessary files and then the following window will be presented.
Click Cancel to complete the installation.
Connecting the iDLMax to the host PC
The USB cable provided is shown below.
Connect the cable to the Host PC (ensure that the PC is switch on and user logged in), connect the other end of the cable to the iDLMax.
Switch the iDLMax on, the Host PC will then detect the device on the USB port and attempt to install the drivers. If the Hardware Installation Wizard
does not find the drivers, then the wizard would prompt to be pointed to the drivers. In this case, point to the files copied above.
After the drivers are installed, Active Sync will automatically detect the iDLMax
Host PC USB Connecto
r
Device USB Connecto
r