User Manual

CHAPTER 1

GETTING TO KNOW YOUR IDLMAX

Product User Guide 2

Using the iDLMax

The Battery Charger

The Battery charger shown above is used to charge an iDLMax battery outside of the iDLMax. The battery charger requires a 12V 3A DC power

supply in order to operate. This is supplied by the PSU.

Connecting power to the battery charger

First, the power lead must be connected into the three-prong connector on the PSU. The power lead plug must then be connected to a power source

and the power source switched on.

Connect the functional PSU into the battery charger by plugging the DC Jack into the connecter marked “12V D.C.”

The red LED marked “Power” on the battery charger will light up to indicate power is present and that battery charger is functional.

Inserting a battery

The iDLMax is supplied with 3.6V, 4000mAh batteries.

In order to charge a battery it must first be inserted into the slot in the battery charger as shown above.

Use only the correct batteries, PSU and battery charger supplied by a MaxID dealer. The use of other equipment can cause

permanent damage to the iDLMax and render the warranty void. For correct supplies contact a MaxID Dealer or visit