Operation Manual

1.PANEL
2.AIR FLOW LOUVER
3.INFRARED SIGNAL
RECEIVER
4.DISPLAY PANEL
5.AIR-IN GRILLE
Please adjust room temperature properly especially when the old men, children, patients
stay at house.
Lightning and other electromagnetic radiation may cause ill effect .If it is ,please plug off the
power switch ,and replug in ,then restart the unit.
Do not block the inlet of indoor unit or outlet of oudoor unit, any of blocks will reduce cooling
or heating efficiency.
FUNCTION AND OPERATION OF PANEL'S PARTS
3
WARNING
!
MAINTENANCE
Before you clean the air conditioner, be sure to disconnect the power supply plug.
CAUTIONS
!
Use a dry cloth to wipe the indoor unit and remote controller.
A cloth dampened with cold water may be used on the indoor unit if it is very dirty.
Never use a damp cloth on the remote controller.
Do not use a chemically-treated duster for wiping or leave such material on the unit for long,
because it may damage or fade the surface of the unit.
Do not use benzine,thinner,polishing powder,or similar solvents for cleaning. These may
cause the plastic surface to crack or deform.
Cleaning the indoor unit and remote controller
If you do not plan to use the unit for at least 1 month.
(1) Operate the fan for about half a day to dry the inside of the unit.
(2) Stop the air conditioner and disconnect power.
(3) Remove the batteries from the remote controller.
ADJUSTING AIR FLOW DIRECTION
Cassette Type
While the unit is in operation, you can adjust the air flow louver to change the flow direction and natu-
ralize the room temperature evenly. Thus you can enjoy it more comfortably.
1.Set the desired air flow direction.
Push the SWING button to adjust the louver to the desired position and push this button again to
maintain the louver at this position.
2.Adjust the air flow direction automatically.
Push the SWING button, the louver will swing automatically..
While this function is set,the swing fan of indoor unit runs;otherwise,the swing fan doesn t run.The
swing scale of every side is 30 .When the air conditioner isn t in operation(including when TIMER
ON is set),the SWING button will be disabled.
ADJUST UP AND DOWN
26