Operation Manual

- 7 -
Each time the MODE button is pressed, the operation mode
is changed in sequence:
Press until your desired mode appears.
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
"I FEEL "mode is specified on page 9.
The compressor does not run in "FAN ONLY " mode.
18 ~32
HEATING
"I FEEL"
COOLING DRY
FAN ONLY
Selecting mode
Select fan speed
2
+
-
AUTO
HI MED
LO
.
At "FAN ONLY" mode, only "HI","MED" and "LO" are available.
While at "DRY"mode, airflow is set by air conditioner automatically,
"FAN" button is ineffective in this case.
Setting temperature
Press once to lower temperature by 1
Press once to raise temperature by 1
Range of available set temperature
HEATING or COOLING
DRY
FAN
unable to set
room temperature
Turning on
Press "ON/OFF" button, when the appliance receives the
signal, a "beep" can be heard, then the RUN indicator
lights up.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
the temperature of the indoor heat exchanger rises.
During heating operation, air flow is not discharged at the beginning. After 2 5 minutes, the flow will be discharged until
1
3
4
2
FAN
ON/OFF
TEMP
SLEEP SWING MODE
CAN
SET TIMER
HEATER
Operation instructions
Operation modes
ONLY