Operation Manual

TIMER
SET
CAN
MODE
SWING
SLEEP
The appliance may not work in the following cases:
How to load batteries
How to use remote controller
Pull to open
the cover.
Load batteries properly
in the compartment
according to polarity.
Push up to close
the cover.
Note:
The service life of an alkaline battery is about 1 year.
When the indoor unit does not response to signal, or
the display becomes dim, replace the batteries at once.
Replace the two batteries with new ones of the same
tape.
To prevent liquid leakage, take out all batteries when
it is not going to be used for a long time.
After replacing batteries, if the remote
controller does not display, take them
out and reload them 20 seconds later.
Be sure to stop the air conditioner
before loading the batteries.
Signal
transmitter
The range that the signal can reach
is about 7m when pointing at the
front of indoor unit.
Signal-sent symbol will flash
for a short time when signal is sent.
No signal
is received
Remote controller
is exposed to
direct sunlight or
strong spotlight
Identification of parts
Remote controller
6
__
"Beep" means
receiving signal
HEATER