Operation Manual

Trial run

Front panel installation

Function test

Before trial run

Switch on the appliance after the checking.

If a "beep" is heard, it basically means the unit works normally, otherwise check it again.

Since the front panel has not been installed, it can not be checked through the indicators and remote controller yet.)

Cover for checking

Checking opening

Drain port

Add some water through a funnel

Remove the cover for checking and add some water(about 2000ml) in through a funnel;

Normally, the floater switch can be seen floating up from the checking opening, and the water

pump starts to drain, which can be seen through the transparent drain port.

If not, check the electrical system of the unit again.

Only after adjustment of levelness and drain system of the unit, do the following:

Remove 4 corner panels from the air inlet grill of front panel as shown above;

After installation and piping, cable connection of both indoor and outdoor units complete,

check the following items:

if the refrigerant leaks;

if power supply complies with requirements;

If control cables and power cord have been fixed well.

Installation instructions