Operation Manual
30
Installation
(Optional)
Installing base using locking clip
• Install the base with the stabilising bar against the back of
the car seat.
• Thread the vehicle lap sash belt combination through the
belt path. Lock tongue into buckle and listen for click.
• Pushdownrmlyonthebaseandpulluponshoulderbelt
until all slack is remove and lap belt is tight.
• Grasp both vehicle belts together and unbuckle.
• Thread both portions of the vehicle belt onto the locking
clip on the opposite side of the buckle. Re-buckle belt.
• Lap belt portion should now be tight. If not, remove
locking clip and repeat all steps.
NOTE: The locking clip must be removed when the
child restraint is not installed to allow other users to
use the seatbelt as a lap-sash seatbelt. The locking
clip shall not create unacceptable slack in the seatbelt.