User`s manual

Section 2 BIOS SETUP & SECURITY
2-7
The Menu of Advanced CMOS Setup
Advanced CMOS Setup for configuring system options.
Item Selections /
Sub-menu
Description
1st Boot
Device
Set the type of device for the 1st boot
drive that BIOS attempts to boot from after
BIOS POST completes.
2nd Boot
Device
Set the type of device for the 2nd boot
drive that BIOS attempts to boot from after
BIOS POST completes.
3rd Boot
Device
Disabled
IDE-0
Floppy
CDROM
Set the type of device for the 3rd boot
drive that BIOS attempts to boot from after
BIOS POST completes.
Boot Up
NumLock
On
Off
Turn the numeric keys on or off as system
boots up.
Password
Check
Setup
Always
[Setup]:
To enable the password check function
every time when BIOS Setup is executed.
[Always]:
To enable the password check function
every time the system boots.
CPU / DRAM
Frequency
66/66MHz,
66/100MHz,
100/100MHz,
100/133MHz,
133/133MHz,
Set the CPU and DRAM working
frequency by the parameters as shown.
Your notebook can't be booted if CPU
does not support the frequency. (Refer
to the warning below.)
Warning:
Your notebook can’t not be booted if the CPU does not support the working
frequency set in BIOS. In this case, you need to reconfigure by following the
instructions.
1) Power on the system and repeatedly press [Pg Up] key located along the
edge of keyboard.
2) After the boot screen, press [Delete] key to activate the BIOS utility.
3) Go to Advanced CMOS Setup > CPU Base Frequency and restore it to
default, 66/66MHz.