User guide

67MAXDATA SR1202 M1 – StorView
®
RAID User Guide
Figure 49. SAN LUN Mapping Screen
5 Add a mapping.
In the “ADD NEW MAP” section, do the following:
(A) Select the logical drive you wish to map to. Click the pull down menu and choose from the list
of logical drives displayed. Default logical drive names are LD1, LD2, LD3, etc.
 NOTE
Logical drives marked with an asterisk “*” indicate that another mapping for another Host HBA has
been established for this logical drive. You can map it again to additional HBA’s but know that all
mapped Host HBAs will see and have access to this logical drive.
(B) Choose the LUN to present the mapped logical drive to the Host system. Click the drop-down
menu and choose the desired number.
(C) Select a access permission for the mapping. Choose from the drop-down menu: Read/Write or
Read Only.
 NOTE
Microsoft Windows does not support Read Only permissions.
(D) Select the Host Port.
Choose from the drop-down menu and select H0, H1, or Both. If you select both, the mapping
will be available to either Host connected to either connector.
(E) Click the ADD MAPPING button.
6. Review your settings, then click the APPLY button.
7. You will receive a confirmation, click the OK button to continue, or CANCEL to exit and return
to the SAN LUN Mapping window.
8. You may continue to create more mappings or end this session by clicking the CLOSE button.