User guide

26 Embedded StorView Setup
Using Dynamic IP (DHCP)
 NOTE
StorView does not display the TCP/IP information when Dynamic IP (DHCP) is selected. You must
use a third-party network administration program to obtain this information.
To use the DHCP Server network interface settings:
1. Click the “radio button” next to Dynamic IP (DHCP).
2. Click the APPLY button to make the changes effective.
3. Click the CLOSE button.
Using Static IP
To manually configure the network interface settings:
1. Click the “radio button” next to Static IP.
2. Enter the desired IP address in the “IP Address” field and press the <Tab> key or click in the
Subnet Mask field.
3. Enter the desired Subnet Mask in the “Subnet Mask” field and press the <Tab> key or click in
the Default Gateway field.
4. Enter the desired
gateway or router address and press the <Tab> key or click in the DNS
Server field.
5. Enter the desired DNS Server IP address.
6. Click the APPLY button to make the changes effective.
7. Click the CLOSE button.
Getting a New IP Address
If you are set up to receive your IP address using Dynamic IP (DHCP), you can force the embedded
StorView server to obtain a new IP address from your DHCP server.
1. Click the Settings button and select the Preferences tab.
2. Click the RENEW button.
3. Click the APPLY button to make the changes effective.
4. Click the CLOSE button.