User guide

25MAXDATA SR1202 M1 – StorView
®
RAID User Guide
4 Embedded StorView Setup
Embedded Network Settings
 NOTE
If you are using the host-based version of StorView, you may skip this chapter.
Upon start-up, embedded StorView looks at the user Preferences Settings to determine if an IP
address exists. If one is defined it will initialize the network interface using that IP address.
In the event an IP address is not defined, it attempts to get a DHCP IP address. You will need to
contact your network administrator for the IP address assigned by the DHCP server. To identify the
new IP address lease, one can look for ‘esv0’ or ‘esv1’ in your DHCP Manager software.
If an IP address cannot be determined, the software will use a default IP address of “10.1.1.5” for
Controller 0 and “10.1.1.6” for Controller 1. If an error is encountered, it will assign the Embedded
StorView Server the IP address “10.1.1.7”.
The first time you start StorView, you will want to configure the network settings.
Configuring Network Settings
1. Click the Settings button on the Main screen and select the Preferences tab.
2. The StorView Server Name field will have a default name, “esv0” for Controller 0 and “esv1”
for Controller 1.
 NOTE
If you wish to change this name, enter the desired name for this embedded StorView server.
Figure 9. Settings Screen - Preference Tab (Dynamic IP Selected)