User guide

26 MFMAXDATA SR1202 M1 – Technical User GuideIntroduction
SR1202 RAID Controller Module Specification
Speed
Host Ports: two 4 Gb/sec Fibre Channel, also supporting 2 Gb/sec and
1 Gb/sec mode
Drive Ports: 3 Gb/s SAS, creates connections to a single domain of 12
drives
Mounting Rear, horizontal in Bay 4 (see Figure 12)
Connectors
2 x SFP connectors for Host 0 and Host 1 Ports, to accommodate the
following interconnects:
a) optical (LC to LC cable), maximum length 500 m
b) copper (100 ohm SFP patch cable) maximum length 1.5 m, or
c) copper SFP, maximum length 10 m
1 x 4xSAS Expansion connector (SFF)
1 x RJ45, 10/100BaseT Ethernet connection (Netburner)
1 x RS232, 6 pin Mini-DIN (factory use only)
Power Consumption 40 W
LED Functions
LED Functions LED State Definition
Controller Slot 0 Activity*
Amber When ON the Controller is currently processing data
Controller Slot 1 Activity*
Amber When ON the Controller is currently processing data
Controller OK
Green Module OK
Controller Fault
Amber Fault on this module
Cache Active
Amber Active cache contents
Battery/Controller Fail
Amber Fault in battery or charger operation of controller
Host 0 Port Signal Good
Green When ON the LED denotes that incoming FC signal is
good
Host 1 Port Signal Good
Green When ON the LED denotes that incoming FC signal is
good
Host 0 Port Traffic*
Amber When ON the Controller is processing data on this
port
Host 1 Port Traffic*
Amber When ON the Controller is processing data on this
port
SAS Expansion 1*
Green When ON this port is active
SAS Expansion 2*
Green When ON this port is active
SAS Expansion 3*
Green When ON this port is active
SAS Expansion 4*
Green When ON this port is active
* These LEDs blink on/off when there is module activity.
Drive Carrier Module Specification
!
IMPORTANT
Operating SR1202 enclosures with non-approved drives may invalidate the warranty. Please contact
your supplier for details of approved drives.
Module Dimensions Height 1.06” (27.05 mm)
Width 4.19” (106.55 mm)
Depth 8.25” (209.55 mm)
Weight 0.88 kg (1.0” 36 Gb drive)
Operating Temperature 5 °C to 40 °C (when installed in an SR1202 system enclosure with dual
Power Supply Modules)
Power Dissipation 18.5 Watts maximum