User`s manual

24 25MAXDATA PLATINUM 100 IInstalling and Replacing Board Components

Table 7. BIOS Error Messages (Continued)

FDC Failure Error occurred trying to access diskette drive controller.

HDC Failure Error occurred trying to access hard disk controller.

Checking NVRAM..... NVRAM is being checked to see if it is valid.

Update OK! NVRAM was invalid and has been updated.

Updated Failed NVRAM was invalid but was unable to be updated

Keyboard Is Locked The system keyboard lock is engaged. The system must be

unlocked to continue to boot.

Keyboard Error Error in the keyboard connection. Make sure keyboard is

connected properly.

KB/Interface Error Keyboard interface test failed.

Memory Size Decreased Memory size has decreased since the last boot. If no

memory was removed, then memory may be bad.

Memory Size Increased Memory size has increased since the last boot. If no

memory was added, there may be a problem with the

system.

Memory Size Changed Memory size has changed since the last boot. If no memory

was added or removed, then memory may be bad.

No Boot Device Available System did not find a device to boot.

Off Board Parity Error A parity error occurred on an offboard card. This error is

followed by an address.

On Board Parity Error A parity error occurred in onboard memory. This error is

followed by an address.

Parity Error A parity error occurred in onboard memory at an unknown

address.

NVRAM / CMOS / PASSWORD cleared

by Jumper

NVRAM, CMOS, and passwords have been cleared. The

system should be powered down and the jumper removed.

<CTRL_N> Pressed

CMOS is ignored and NVRAM is cleared. User must enter

Setup.