User`s manual

76 MFMAXDATA PLATINUM 7200 IR M6Replacing the CMOS Battery

CAUTION

Do not attempt to pull the battery up until it is pushed clear of the smaller prongs. Doing so may

damage the battery holder on the Main Board.

Figure 13. Removing the Battery

9. Dispose of the battery according to local ordinance.

10. Remove the new lithium battery from its package.

11. Being careful to observe the correct polarity, insert the battery at an angle into the battery

socket with the edge of the battery under the larger prongs in the battery socket.

12. Push the battery toward the larger prongs while pushing down on the raised edge of the

battery until it clicks into place under all four prongs.

13. Install the Memory Board or the Memory Board air baffle into slot A. For instructions, see

“Cold Insertion of a Memory Board”.

14. Install the top cover. For instructions, see “Installing the Top Cover”.