User`s manual

74 MFMAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components
Removing DIMMs
CAUTION
Use extreme care when removing DIMMs. Too much pressure can damage the connector. Apply
only enough pressure on the plastic levers to release the DIMM.
1. Remove the top cover. For instructions, see “Removing the Top Cover”.
2. Remove the Memory Board. For instructions, see “Hot Removal of a Memory Board” or “Cold
Removal of Memory Board”, depending on your server configuration.
3. Remove the Memory Board DIMM cover from the Memory Board:
- Pull out on the latch.
- Press on the tab.
- Press on the tab.
- Lift the Memory Board DIMM cover from the Memory Board.
4. Open the plastic levers on each end of the DIMM socket(s). The DIMM will lift from the
socket.
5. Hold the DIMM only by the edges. Do not touch the DIMM components or the gold edge
connectors. Store it in an antistatic bag.
6. Install replacement DIMMs if necessary. For instructions, see “Installing DIMMs”.
7. Install the Memory Board DIMM cover on the Memory Board:
- Line up the two tabs.
- Press on the tab.
8. Install the Memory Board or install a Memory Board air baffle into the Memory Board slot. For
instructions, see “Hot Insertion of a Memory Board” or “Cold Insertion of a Memory Board”,
depending on your server configuration.