User`s manual

72 73MAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components
72 73MAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components
Installing DIMMs
CAUTIONS
Use extreme care when installing a DIMM. Applying too much pressure can damage the connector.
DIMMs are keyed and can be inserted in only one way.
Hold DIMMs only by the edges. Do not touch the components or gold edge connectors.
Install DIMMs with gold-plated edge connectors only.
The maximum DIMM height is 4.445 cm (1.75 inches). Do not install DIMMs that exceed this
height.
 NOTE
DIMM slots on the memory module must be installed only in certain configurations. Numbers next
to DIMM slots correspond to installation sequence. DIMMs must be installed by groups of two.
1. Remove the top cover. For instructions, see “Removing the Top Cover”.
2. Remove the Memory Board. For instructions, see “Hot Removal of a Memory Board” or “Cold
Removal of Memory Board”, depending on your server configuration
3. Remove the Memory Board DIMM cover from the Memory Board:
- Pull out on the latch.
- Press on the two tabs.
- Press on the tab.
- Lift the Memory Board DIMM cover from the Memory Board.
4. Open the plastic levers on each end of the DIMM socket(s).
5. Remove the DIMM from its antistatic container. Hold the DIMM only by the edges. Do not
touch the components or gold edge connectors.
6. Install DIMMs in the correct order. See “Rules for Adding Memory”.
7. Position the DIMM above the socket. Align the notch on the bottom edge of the DIMM with
the key in the DIMM socket.
8. Insert the bottom edge of the DIMM into the socket.
9. Push down on the top edge of the DIMM. The levers at each end of the DIMM socket will
close. Make sure the levers close securely.
10. Install the Memory Board DIMM cover on the Memory Board:
- Line up the two tabs.
- Press on the tab.
11. Install the Memory Board. For instructions, see “Hot Insertion of a Memory Board” or “Cold
Insertion of a Memory Board”, depending on your server configuration.