User`s manual
70 71MAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components
70 71MAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components
Hot Insertion of a Memory Board
1. Add or replace memory DIMMs as needed. For instructions, see “Installing and Removing
DIMMs”.
2. Ensure the handle on the Memory Board is in the open / up position.
3. Align the ends in the card guides and slide the Memory Board into the Memory Board slot.
4. Push the handle down into the fully-locked position.
5. Install the top cover. For instructions, see “Installing the Top Cover”.
Cold Removal of Memory Board
NOTE
If you remove a Memory Board from your server, you must either replace it with a replacement
Memory Board or you must install a Memory Board air baffle.
1. Observe the safety precautions, warnings, and cautions described in “Safety Information”.
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords.
4. Remove the top cover. For instructions, see “Removing the Top Cover”.
5. Press the latch on the handle and lift the Memory Board handle.
6. Pull up on the Memory Board handle to lift the Memory Board from the server.
7. Install DIMMs, then reinstall the Memory Board, or install a Memory Board air baffle:
- For instructions to install DIMMs, see “Installing and Removing DIMMs”.
- For instructions to install the Memory Board air baffle, see “Cold Insertion of a Memory
Board”.
8. Install the top cover. For instructions, see “Installing the Top Cover”.
Cold Insertion of a Memory Board
1. Observe the safety precautions, warnings, and cautions described in “Safety Information”.
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords.
4. Remove the top cover. For instructions, see “Removing the Top Cover”.
5. Install DIMMs onto the Memory Board. For instructions, see “Installing and Removing
DIMMs”.
6. Remove a Memory Board air baffle from the server. For instructions, see “Cold Removal of
Memory Board”.
7. Ensure the handle on the Memory Board is in the open / up position.
8. Align the ends in the card guides and slide the Memory Board into the Memory Board slot.
9. Push the handle down into the fully-locked position.
10. Install the top cover. For instructions, see “Installing the Top Cover”.