User`s manual

60 61MAXDATA PLATINUM 7200 IR M6User Serviceable Platform Components

Removing a Hard Disk Drive

1. Observe the safety, ESD, and other precautions described in “Safety Information.”

2. Press on the green drive carrier latch.

3. Pull the handle to remove the drive cage from the chassis.

4. Place the drive cage on a clean, static-free work surface.

Mounting a Hard Disk Drive in a Carrier

To mount a hard drive in a carrier:

1. Observe the safety, ESD, and other precautions described in “Safety Information.”

2. Remove the hard disk drive from the protective wrapper and place it on a clean ESD-protected

work surface.

3. Set any jumpers and/or switches on the drive according to the drive manufacturer’s

instructions.

4. If the drive carrier is installed in the chassis, remove it and place it on a clean static-free work

surface. For instructions, see “Removing a Hard Disk Drive”.

5. Remove the four screws that hold the air baffle in place.

6. Remove the air baffle from the carrier.

7. Store the air baffle for future reinstallation.

8. Position the drive in the carrier with the label-side up and the connector end of the drivefacing

the back of the carrier.

9. Align the holes in the drive to the holes in the drive carrier slide track and insert the screws

that you were attached to the air baffle.

Installing a Hard Disk Drive Assembly

1. Observe the safety, ESD, and other precautions described in “Safety Information”.

2. With the drive carrier handle fully open, slide the drive carrier all the way into the drive bay in

the chassis.

3. Use the handle to push the carrier until it docks in the chassis, then close the drive carrier

handle.