User`s manual

40 Troubleshooting
LED Information (Continued)
LED Name Function Location Color Description
Hot-plug
PCI Power
(hot plug
PCI system
only)
Identify the
power state for
the hot-plug PCI
slot
Inside the system,
at the front of PCI
slots 1, 3, 4, and 5
Green • On = Power is on to the PCI
slot. DO NOT REMOVE THE
PCI CARD.
• Off = Power is off to the
associated PCI slot.
• Blinking = Slot is
transitioning between on and
off. DO NOT REMOVE THE PCI
CARD
Hot-
plug PCI
Attention
(hot plug
system PCI
only)
Indicates a fault
condition has
occurred
Inside the system,
at the front of PCI
slots 1, 3, 4, and 5:
At the rear of the
chassis, visible
from the exterior
of the system (only
if the hot plug PCI
light pipe kit is
installed)
Amber • Off = Slot and card are
functioning without error.
• On = A failure has occurred.
• Blinking = Slot needs
attention
BIOS POST Beep Codes
The table below lists the POST error beep codes. Prior to system video initialization, the BIOS uses
these beep codes to inform users of error conditions. The beep code occurs only when a critical
error occurs or when the BIOS fails to boot to the operating system. Please note that not all error
conditions are supported by BIOS beep codes.
Table 9. Boot Block Error Beep Codes
Number of Beeps Description
1 Insert diskette in floppy drive A:
2 ‘AMIBOOT.ROM’ file not found in root directory of diskette in A:
3 Base Memory error
4 Flash Programming successful
5 Floppy read error
6 Keyboard controller BAT command failed
7 No Flash EPROM detected
8 Floppy controller failure
9 Boot Block BIOS checksum error
10 Flash Erase error
11 Flash Program error
12 ‘AMIBOOT.ROM’ file size error
13 BIOS ROM image mismatch (file layout does not match image
present in flash device)
1 long beep Insert diskette with AMIBOOT.001 File for Multi-Disk Recovery