User`s manual

29MAXDATA PLATINUM 5220 Server
5 Hardware Installations and Upgrades
Before You Begin
Before working with your server product, pay close attention to the safety information in ‘Server
Position’ at the beginning of this manual.
Tools and Supplies Needed
• Phillips (cross head) screwdriver (#1 bit and #2 bit)
• Needle-nosed pliers
• A ruler
• Pen or pencil
• Anti-static wrist strap and conductive foam pad (recommended)
Installing or Replacing the Processor
 NOTES
Use the instructions provided below to install or replace a processor instead of using the instructions
that came with the processor.
CAUTIONS
Processor must be appropriate: You may damage the server board if you install a processor that
is inappropriate for your server.
ESD and handling processors: Reduce the risk of electrostatic discharge (ESD) damage to the
processor by doing the following: (1) Touch the metal chassis before touching the processor or server
board. Keep part of your body in contact with the metal chassis to dissipate the static charge while
handling the processor. (2) Avoid moving around unnecessarily.
Installing the Processor
To install a processor, follow these instructions:
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord from the server.
4. Remove the server’s cover and locate the processor sockets.
TP00726
A
a
Figure 19. Opening Socket Lever