User`s manual

12 13MAXDATA PLATINUM 300 IR M6Board Features
12 13MAXDATA PLATINUM 300 IR M6Board Features
Configuration Jumpers
Figure 3 shows the location of the configuration jumpers.
Figure 3. Configuration Jumpers
Table 3. Configuration Jumpers
Jumper Name What happens at system reset...
CMOS Configuration Pins 1-2 should be jumpered for normal system operation.
If pins 2-3 are jumpered, the system will enter a configuration
menu that is only available by jumpering these pins. These
pins should NOT be jumpered for normal operation.
If the jumper is removed, the system will attempt to recover
the BIOS by loading the BIOS code into the flash device from
a floppy disk. This is typically used when the BIOS has become
corrupted. The jumper should NOT be removed for normal
operation.
Clear CMOS Pins 1-2 should be jumpered for normal system operation.
If pins 2-3 are jumpered, the CMOS settings will be cleared on
the next reset. These pins should NOT be jumpered for normal
operation.
3
2
3
2
B
A
Off - Recovery
CMOS Configuration
Jumper (J9H3
Config
Normal
Clear CMOS Jumper
(J9G3)
Clear
Normal